STEPS FOR INSTALLING ARLO BASE STATION
Connect the Arlo base station's power cord to it, then plug the other end into a wall socket. In order to start your base station, push the power button.
Next, take an Ethernet cable and attach it to the base station to connect your wireless router to it.
Wait until the internet and power lights turn completely green.
The Arlo base station has been set up. To start with the primary setup procedure, you can adhere to the procedures listed below.
GETTING READY YOUR ARLO CAMERAS
Take an Arlo camera, then press and hold the battery box open for a bit.
After carefully aligning the batteries inside the Arlo camera, close the battery compartment.
Your Arlo camera is now prepared for synchronisation with the Arlo base station.
SYNC CAMERA WITH THE BASE STATION
You must put the Arlo wireless camera and base station within 100 metres of one another in order for them to sync.
Now, hold down the "Sync" button on the Arlo base station with your index finger for a while. Only press the button once the light becomes green.
Find the sync button on the Arlo camera's rear and press it firmly for a few seconds.
The Arlo camera is synced to the Arlo base station if it has a blue LED on the front. If the LED is amber, your attempt to sync with the base station was unsuccessful.
Other Arlo cameras will, however, also follow the same procedure.
If you are facing any computer and other devices related issues, checkout the list below:-
TP Link Smart Plug | 192.168.1.1 | TP Link Drivers | Belkin Extender Setup | BT Mail | Spectrum Login | ij.start.cannon | Navman Update | Arlo Login | Home.mcafee.com | Disneyplus.com login/begin | Disneyplus.com/begin | Roadrunner Email | Garmin Express